DURAJOINT® ANCHOR-BOND GEL EPOXY
Durajoint® Anchor-bond Gel Epoxy is a high viscosity, hi-mod, high strength bonding and anchoring gel epoxy. It is a two-component, moisture insensitive construction epoxy. It is solvent-free, low odor, and non-sag.
- Applications
- Properties
- Packaging
- Instructions & Storage
Applications
Durajoint® Anchor-Bond Gel Epoxy can be used for a variety of applications including:
- Durajoint® PVC & TPER Retro-fit Waterstop Profiles
- Anchor bolts, dowels, and reinforcing steel
- Concrete, block, brick and stone
- Vertical and overhead structural bonding and patching
Typical Properties
| Mix Ratio | 1:1 |
| Gel Time (ASTM 881) | 45 minutes |
| Typical Cured Properties | |
| Cure Time | 24 hours |
| Compressive Strength (ASTM D695) | 11,230 psi |
| Compressive Modulus (ASTM D695) | 326,500 psi |
| Bond Strength in 2 days | 2,460 psi |
| Bond Strength in 14 days | 3,280 psi |
| Elongation (ASTM D638) | 1.3% |
| Tensile Strength (ASTM D638) | 7,210 |
| Water Absorption (ASTM D570) | < 0.5% |
| Heat Deflection (ASTM D648) | 133°F |
Packaging
22oz. Dual Cartridge
12 Cartridges / Carton
Mixing Instructions
Air, material and surface temperatures must be a minimum of 40°F prior to mixing or installation. To assist with mixing and dispensing, precondition material to 75°F. The resin and hardener are uniformly dispensed and mixed simultaneously through a mixing nozzle.
Storage & Shelf Life
Store in its original container and keep tightly closed. Do not allow accumulation of water, dirt or other contaminates. The shelf life if stored properly is two years from the manufacture date.